Multi-axis measurement ,more precision and truly reflect wire & tube conditions
F4010- K is high-speed measurement model on the basis of F series ,aiming at providing better quality control solutions for customers in wire&tube industr y. It is applicable to diameter measurement ,and the detection of lumps and necks.
With 4 -axis measurement solution, there is less blind area, satisfying customers' request of continuous production of high quality products.
With a measurement repeatability of ±0.2um, F4010-k is versatile, applicable to various materials such as electric wire & cable, steel wire, enamelled copper wire, medical tubing, 3D filament, and so on.
4-axis measurement ,Less bind area
The below figure explains the relation between the measurement result and nos of axis. The more nos of axis, the less bind area it is , and measurement accurate will be more accurate.
High speed line outside diameter measurement
Multi-axis high speed measurement , data collectionis more comprehensiveand accurate , High sampling frequency of 10KHz/second/axis, 4- axis measurement solution, truly reflecting the wire & tube conditions.
Application
Technical Specification
| Model | F4010-K |
| Axis | 4-axis |
| Measurement data | diameter and ovality, lump and necks |
| Frequency | 10KHz/axis |
| Measurement range | 0.3~10mm |
| Repeatability(1) | ±0.2μm |
| Accuracy(2) | diameter accuracy:±(0.001+0.01%*D)mm ovality accuracy: ＜0.5mm:±0.004mm ≥0.5mm: ±2(0.001+0.01%*D)mm |
| Min defect height | 0.01mm |
| Min defect length(3) | 0.2mm(wire speed120m/min)
0.8mm(wire speed500m/min) |
| Size | 275*242*60mm |
| Working power source | 24V ±10% 40VA |
| Running temperature | 5℃~50℃ |
| Display | LED display |
| Commuincation port | Standard:WIFI,RS485 MODBUS RTU,CAN
Option:PROFIBUS,PROFINET, EtherNet/IP,EtherCAT |
| Electrical port | Standard: digital output(relay),digital input,analog input,encoder pulse input port
Option:PI feedback control(4) |
| Data colletion & analysis | available (option DS14 ZT display and control system,DMS1000) |
| Out-of-tolerance alarm | available |
| Transparent mode | available |
Note:
(1) set sliding window as 100ms, outside diameter repeatability of φ1mm round rod at measurement center area
(2) set sliding window as 100ms, outside diameter deviation of φ1mm round rod at measurement area
(3) set defect measurement average time as 0ms, the minimum defect length which cannot be missed at the measurable area
(4) PI feedback control is option, but must order at placing order
